SYDFEE-2X/140R-PSD62KC2-0000-A0A0VXX

The SYDFEE-2X/140R-PSD62KC2-0000-A0A0VXX control unit belongs to the SYD Hydraulic Control Systems series and is produced by Bosch Rexroth to regulate pressure and flow in automated hydraulic circuits. It is supplied from a 24 V DC line, with an allowable span from 21 V to 35 V, so embedded power supplies can fluctuate without service interruption. During normal duty the electronics draw 0.6 A, while brief inrush peaks are tolerated up to 1.25 A to actuate solenoid stages. An analog command channel presents a 100 Ω input load, enabling standard current-loop transmitters to drive the module without excessive burden. The integrated monitoring channel provides up to 1.5 mA of analog output for closed-loop diagnostics. A 12-pole X1 central connector consolidates power, signal, and sensor lines to simplify panel wiring. Digital inputs recognize a logic-0 when the line is held below 0.6 V and a logic-1 once the level exceeds 21 V, preventing false triggers in noisy industrial cabinets.

The hydraulic section withstands operating pressures up to 280 bar, allowing the unit to command proportional valves in high-pressure manifolds. Reliable performance is maintained in ambient temperatures from 0 °C to 60 °C, so machine builders can mount the controller near heat-generating power packs. When the plant is idle, storage temperatures may range from 0 °C to 70 °C without degrading electronic components or seals. An IP65 enclosure protects against dust ingress and low-pressure water jets, making additional housings unnecessary in most factory environments. This thermal and environmental resilience keeps calibration stable during daily start-ups and shutdowns. The pressure capability, temperature limits, and enclosure rating together qualify the product for decentralized hydraulic automation where electrical and fluid stresses coexist. All parameters align with standard industrial control practices applied by Bosch Rexroth across the SYD series.