SYDFEE-2X/140R-PPB12N00-0000-A2A0VX1

The SYDFEE-2X/140R-PPB12N00-0000-A2A0VX1 belongs to the SYD Hydraulic Control Systems series and is produced by Bosch Rexroth for closed-loop hydraulic automation. It conditions electrical power at a nominal supply voltage of 24 VDC so the internal electronics drive proportional valves accurately. A lower voltage limit of 21 V and an upper limit of 35 V define the allowable supply range and protect the control logic from undervoltage or overvoltage faults. The rated current draw is 0.6 A during steady operation, while a maximum current of 1.25 A is accepted for transient load events such as rapid valve shifts. A current input load of 100 Ω matches common sensor loops and prevents excessive burden on upstream transmitters. The unit supplies a pressure feedback signal of 1.5 mA or 10 V so a higher-level controller can monitor system pressure without separate converters. Its hydraulic section is built for a maximum operating pressure of 280 bar, enabling use in medium-pressure circuits found in mobile machinery.

For positional control, the device offers a swivel-angle feedback channel that delivers 1.5 mA or 10 V, allowing a single interface to report displacement. An IP65 enclosure shields the circuitry from dust ingress and water jets, letting the controller mount directly on machinery frames near oil spray. Reliable function is maintained between ambient temperatures of 0 °C and 60 °C, covering typical plant and outdoor conditions, while storage temperatures between 0 °C and 70 °C prevent damage during warehousing. A sealed connector interface aligns with the enclosure rating and keeps signal lines secure in vibrating environments. Mounting the controller close to the actuator shortens hose length and reduces latency in hydraulic response. These environmental and mechanical allowances support precise motion control in presses, steering systems, and lifting modules that depend on hydraulic accuracy.