TZ10GH5N5KA05000

The TZ10GH5N5KA05000 hydraulic actuator belongs to the Hydraulic Cylinders series from Vickers and is intended to convert pressurized fluid into controlled linear motion for automated tooling and clamping systems. It is rated for a nominal pressure of 3000 psi (210 bar), allowing it to integrate with common industrial power units. A 3.25 in bore size defines the piston area and the thrust that can be generated at system pressure. Stroke length is 5.625 in, giving adequate travel for positioning tasks while keeping the envelope compact. The 1.375 in rod diameter supplies the axial strength needed to resist buckling under load, and the rod end is finished with a small male UN thread so users can attach joints or clevises without additional machining.

Mounting is handled by a cap clevis (MP1) arrangement, letting the cylinder pivot on a single pin for alignment with moving members. Cushions are installed at head 1 and cap 1 to slow the piston at each end of travel; these cushions are approved for pressures up to 4500 psi (310 bar), preventing impact damage during rapid cycling. Fluid connections are located at head 1 and cap 4, giving designers flexibility when routing extend and retract lines. Each port follows the NFPA SAE/UN standard and is tapped to 11/16-12 UN (-12) straight thread, ensuring compatibility with readily available hydraulic fittings.