DG4V52CJMUH729EN124

The DG4V52CJMUH729EN124 is produced by Vickers as part of the DG4 Directional Valves series for hydraulic automation circuits. The unit shifts flow paths by means of a solenoid-operated actuation so that electronic signals trigger position changes without manual intervention. The coil is rated for 24 VDC, allowing direct connection to common low-voltage control panels in mobile or industrial machinery. With a power consumption of 38 W, the electrical load remains moderate and can be supplied by standard control transformers. An ISO 4400 (DIN 43650) connector provides a sealed electrical interface that simplifies field wiring and replacement. The product is supplied without an indicator light, so operational status must be monitored through external sensors or controller feedback. It mounts on an ISO 4401-05 subplate, and its 4.590-inch height helps designers estimate the vertical clearance required inside a manifold stack.

The assembly withstands a maximum operating pressure of 315 bar, enabling use in high-pressure circuits found in presses or mobile equipment. A rated flow capacity of 120 L/min defines the upper limit of volume that can pass through the spool without excessive pressure drop. Petroleum oils are the approved working fluids, ensuring seal compatibility and predictable viscosity behavior across typical temperature ranges. The cleanliness code of 19/17/14 specifies the allowable particle counts, indicating that filtration is needed to maintain spool reliability. Overall length measures 12.280 inches, which affects manifold spacing and cabinet depth. A width of 2.800 inches permits side-by-side mounting with minimal center distance between adjacent units. These dimensional and fluid limits combine with the electrical characteristics described earlier to define the installation envelope and performance range of the DG4V52CJMUH729EN124 in automated hydraulic systems.