4WE6Y6X/EG24N9DK25L/62 AN

The 4WE6Y6X/EG24N9DK25L/62 AN directional spool valve is produced by Bosch Rexroth as part of the WE Directional Spool Valves series and routes pressurized fluid in automated hydraulic circuits. Size 6 (NG6) defines its mounting footprint, allowing installation on standard subplates, while the ISO 4401-03-02-0-05 and NFPA D03 porting pattern aligns the body ports with common manifold layouts for rapid exchange. A maximum flow of 80 l/min lets the valve handle moderate circuit volumes without excessive pressure drop, and the 350 bar pressure limit for ports P, A, and B permits use in high-pressure systems. Continuous energization is supported by a 100 % duty cycle, so the solenoids can remain powered without cooling intervals. Its 24 V DC coil voltage fits low-voltage control panels, and at that voltage the coil draws 1.25 A, matching typical driver card capabilities. Nominal consumption of 30 W keeps electrical demand modest while maintaining reliable shifting force.

Environmental and service features further support reliable operation. The IP65 protection class seals the coil housing against dust and low-pressure water jets, enabling installation in exposed machine areas. A concealed manual override identified by code N9 permits spool actuation during setup or power loss while preventing accidental operation. Connector designation DK25L defines the electrical interface and ensures compatibility with matching plug assemblies. Hydraulic fluid cleanliness must not exceed ISO 4406 class 20/18/15, which prolongs spool and bore life. Tank port t is limited to 210 bar to protect the return circuit from over-pressure. The coil surface may reach 120 °C under continuous load, so adjacent components must tolerate that temperature. With two solenoids installed, the valve weighs 1.95 kg, allowing easy handling during maintenance or manifold replacement.