4WE6R10-6X/EG24N9K4/62SO43A-1042

The 4WE6R10-6X/EG24N9K4/62SO43A-1042 is a solenoid-actuated member of the WE Directional Spool Valves series from Bosch Rexroth. It shifts hydraulic flow paths in mobile or stationary automation circuits to start, stop, or reverse actuator motion. The valve is built to nominal size 6, so it fits mounting interfaces standardized for NG6 cavities. Its ISO 4401-03-02-0-05 porting pattern aligns with subplates that follow the same code to simplify block assembly. A maximum direct-current flow of 80 l/min can pass through the body without exceeding design velocity limits. Pressure at ports P, A, and B can rise to 350 bar, allowing the unit to control high-pressure circuits, while the return port T is limited to 210 bar when operated on direct current, preventing case seal overload. The coil is rated for a 100 percent duty cycle, so continuous energization will not overheat the winding. Nominal electrical power consumption is 30 W, and the solenoid accepts a 24 V DC signal compatible with standard machine control outputs.

The solenoid draws a rated current of 1.25 A at the nominal voltage, enabling simple calculation of fuse values. Operation remains stable across a ±10 percent voltage tolerance, so brief supply deviations do not interrupt spool positioning. Power reaches the coil through a DIN EN 175301-803 plug coded K4, offering quick replacement without rewiring, and the housing attains an IP65 ingress rating once the connector is installed, keeping dust and water jets from entering. The magnetic system supports a maximum switching frequency of 4.2 cycles per second, which suits rapid directional shifts in servo loops. A concealed N9 manual override permits emergency actuation without disturbing the electrical circuit. Hydraulic media must meet ISO 4406 class 20/18/15 to limit wear on the precision spool lands, and accurate alignment on the subplate is maintained by the /62 locating hole and locking pin arrangement.