4WE6J6X/EW110N9DAL/N10/62

The 4WE6J6X/EW110N9DAL/N10/62 is manufactured by Bosch Rexroth and belongs to the WE Directional Spool Valves series. It directs hydraulic flow between pressure, actuator, and tank lines to automate position or force control in industrial machinery. The component follows the ISO 4401-03-02-0-05 mounting pattern, also identified as NFPA D03, so it attaches directly to standardized subplates without adapters. A nominal size of 6 establishes the port diameter and ensures compatibility with pumps and cylinders found in medium-capacity systems. Electrical actuation is supplied by a 110 V coil that operates on either 50 Hz or 60 Hz mains, giving flexibility in global installations. The solenoid draws 220 VA during switch-on to generate the magnetic force needed to shift the spool reliably, then stabilizes at a holding requirement of 50 VA to minimize heat and energy consumption during sustained activation.

The coil is specified for a 100 % duty cycle, so it may remain energized continuously without thermal rest periods. A concealed manual override lets technicians reposition the spool during commissioning while protecting the control face from accidental activation in service. Wiring enters through a 1/2″-14 NPT cable gland, and the housing carries an IP65 ingress rating that blocks dust and low-pressure water jets in wash-down areas. Hydraulic limits include a maximum operating pressure of 350 bar on ports A, B, and P, a tank-port rating of 160 bar, and a permissible flow of 60 l/min, together covering a broad range of circuit demands. Switching speed is capped at two cycles per second to maintain spool stability and reduce wear. A Ø1.0 mm throttle insert is fitted in ports A and B to damp pressure surges. The assembled valve weighs 1.95 kg, which allows single-worker installation without lifting devices.