4WE6J6X/EG24N9DK25L AN

The 4WE6J6X/EG24N9DK25L AN directional spool valve is built by Bosch Rexroth for the WE Directional Spool Valves series and is used to switch hydraulic flow in automated circuits. It is supplied in size 6, allowing installation on compact manifold plates in machine tools and mobile equipment. The J spool symbol defines its metering lands so that flow is directed between pressure and service ports according to standard actuation positions. The valve withstands a maximum pressure of 350 bar on the pressure, A, and B lines, enabling high-pressure actuation of cylinders and motors. When shifted, it can carry up to 80 liters per minute, supporting medium flow rates in industrial power units. The solenoid coil operates at 24 V DC, matching common control voltages in factory automation panels. During continuous energization it draws 1.25 A, corresponding to a nominal power consumption of 30 W for predictable load sizing on power supplies. The electromagnetic actuator is rated for a 100 percent duty cycle (operating mode S1), so the spool may remain energized without thermal limitations.

The subplate footprint follows the ANSI B93.9 porting pattern, simplifying interchange with other NFPA D03 components. An IP65 protection class seals the coil housing against dust and low-pressure water jets, making the assembly suitable for washdown zones. Electrical connection is made through a DK25L five-pole connector, providing quick plug-in wiring and auxiliary contacts where required. For manual commissioning or emergency actuation, a concealed N9 override lets technicians shift the spool without energizing the solenoid. Drain flow returning to reservoir is limited to 210 bar on the tank port, ensuring housing seals are not overstressed. Hydraulic cleanliness must not exceed ISO 4406 class 20/18/15, preserving spool clearances and maintaining low wear. With two solenoids installed the valve weighs 1.95 kg, allowing easy handling during assembly or service.