4WE6H6X/EG24N9DK35L/62 AN

The 4WE6H6X/EG24N9DK35L/62 AN directional spool valve belongs to the WE Directional Spool Valves series and is built by Bosch Rexroth to route hydraulic fluid between pressure, work, and tank ports in automated machinery. It attaches to subplates that follow the ANSI B93.9 D03 interface, so installers can fit it to standard CETOP 03 manifolds without adapter blocks. A maximum operating pressure of 350 bar allows the valve to survive high-pressure circuits found in presses and injection equipment, while a direct-current flow capacity of 80 l/min lets it handle medium pump outputs without excessive pressure drop. The solenoid pair runs on a nominal 24 V DC supply; with a rated current of 1.25 A and a nominal power draw of 30 W, cabinet designers can size wiring and fusing accurately. A voltage tolerance of ±10 % keeps actuation reliable when supply rails fluctuate, and a 100 % duty cycle rating means the coils may remain energized continuously. The assembled unit weighs 1.95 kg, which supports single-hand installation.

Electrically, the coils terminate on an M12 × 1 four-pole connector, enabling quick disconnects and standardized cord sets in modular machines. An IP65 enclosure prevents dust ingress and low-pressure water jets from reaching the windings, supporting operation on open factory floors. For manual commissioning or fault recovery, a concealed N9 override lets technicians shift the spool without energizing the solenoid. The locating hole includes a 3 × 8 mm ISO 8752 spring pin, which secures the valve on the subplate against vibration. When the spool returns, a switch-off overvoltage limit of 500 V protects driver electronics from inductive spikes. Tank port pressure is permitted up to 210 bar in dynamic service, so back-pressure in the return line will not damage the housing seals.