Bosch Rexroth | 4WE6E6XEW100N9DJLB1062
4WE6E6X/EW100N9DJL/B10/62
Request a Quote
Call For Quote
What Happens Next?
Email Confirmation
You will get an email confirming we have received your inquiry.
Dedicated Account Manager
A team member will review your request and be in touch concerning any questions or specifications.
Quote Delivered
You will receive a comprehensive quote tailored to your specific needs.
The 4WE6E6X/EW100N9DJL/B10/62 directional spool valve is produced by Bosch Rexroth for the WE Directional Spool Valves series. It shifts hydraulic flow between ports to actuate cylinders and motors in automated machinery. The valve is supplied in size 6 and follows the porting pattern ISO 4401-03-02-0-05 for direct mounting on standard subplates. Its spool symbol E defines the internal connections that route pressure to actuator lines in the required sequence. A throttle insert with a 1.0 mm orifice in port P, identified as B10, restricts inrush flow to control acceleration of connected loads. The assembly supports a maximum flow of 60 l/min, making it suitable for medium-capacity circuits. Operating pressure at ports P, A, and B reaches 350 bar, allowing use in high-pressure systems. The solenoid is energized from a 100 V 50/60 Hz supply and demands 220 VA at switch-on to overcome static friction. Continuous energization is permitted because the duty cycle is 100 % ED.
During the hold state the coil power requirement falls to 50 VA, reducing thermal load during extended operation. Electrical cabling is attached by a central DJL connector that simplifies installation in confined manifolds. A concealed N9 manual override lets maintenance personnel shift the spool without electrical power while protecting the mechanism from dirt. Tank port pressure is limited to 160 bar, so return lines and reservoirs must be selected accordingly. A locating hole and pin in the subplate interface match the ISO 8752-3x8-St standard to ensure precise alignment. The housing achieves an IP65 protection class, preventing dust ingress and withstanding low-pressure water jets in typical industrial environments. With two solenoids installed the valve weighs 1.95 kg, allowing single-operator installation.
Technical Specifications
Duty Cycle
100% ED
Electrical Connection
DJL (central)
Holding Power
50 VA
Locating Hole And Pin
ISO 8752-3x8-St
Manual Override
N9 (concealed)
Max Flow (ac)
60 l/min
Max Operating Pressure (p/a/b)
350 bar
Max Tank Port Pressure (ac)
160 bar
Nominal Voltage
100 V 50/60 Hz
Porting Pattern
ISO 4401-03-02-0-05
Protection Class
IP65
Size
6
Spool Symbol
E
Switch-on Power
220 VA
Throttle Insert
Port P Ø1.0 mm (B10)
Weight (two Solenoids)
1.95 kg
1620 Old Apex Road
Shipping & Payment Options
