4WE6D6X/EG24N9K4QMBG24/ZV

The 4WE6D6X/EG24N9K4QMBG24/ZV valve belongs to the WE Directional Spool Valves series from Bosch Rexroth. Designed to shift hydraulic flow paths under electrical command, it serves automated circuits where reliable on-off control is required. A nominal voltage of 24 V DC energizes the solenoid, while a ±10 % voltage tolerance allows operation on supplies that vary slightly in mobile or industrial plants. The coil draws a rated current of 1.25 A and consumes 30 W, a combination sized for continuous service; the 100 % duty cycle confirms that the coil may remain energized without enforced cooling intervals. To support this uninterrupted load, the coil surface is permitted to reach 120 °C without damage. Electrical connection is made through a 3-pole (2 + PE) DIN EN 175301-803 plug, simplifying field wiring and grounding. When the command signal is removed, the winding withstands switch-off transients up to 500 V, protecting driver electronics. An IP65 housing keeps dust and water jets from reaching internal parts during wash-down or outdoor use.

The hydraulic interface follows the ISO 4401-03-02-0-05 (D03) porting pattern, so the valve bolts directly onto standard subplates without adaptors; a clamping length of 22 mm provides the necessary engagement for secure fastening. Flow capacity reaches 80 l/min in direct current operation, enabling medium-sized actuators to move at production speeds. Working ports a, b, and p tolerate pressures up to 350 bar, while the tank port t is limited to 210 bar, guiding circuit designers on return line sizing. An FKM seal set resists high-temperature oils and aggressive fluids to maintain leakage control over long service intervals. These hydraulic limits and material selections make the valve suitable for closed-loop presses, mold clamps, and other installations that demand durable spool guidance under frequent cycling.