Bosch Rexroth | PV7-1X06-10RA01MA0-10
PV7-1X/06-10RA01MA0-10
Request a Quote
In-Stock, Ships 3-5 Days
What Happens Next?
Email Confirmation
You will get an email confirming we have received your inquiry.
Dedicated Account Manager
A team member will review your request and be in touch concerning any questions or specifications.
Quote Delivered
You will receive a comprehensive quote tailored to your specific needs.
The PV7-1X/06-10RA01MA0-10 adjustable vane pump is manufactured by Bosch Rexroth for the PV7 Adjustable Vane Pumps series and provides variable flow for hydraulic automation systems. Its displacement is 10 cm³ per revolution, so each shaft turn delivers a fixed volume for precise metering. A maximum flow of 18.0 l/min defines the upper delivery rate available to actuators. The pump tolerates a maximum operating pressure of 100 bar, establishing the highest load it can transmit to the circuit. A maximum shaft torque of 50 Nm indicates the driving motor capacity needed under peak pressure. The minimum speed is 900 rpm, ensuring adequate oil film formation on internal surfaces. A cylindrical drive shaft with key to ISO 3019-2 offers secure power transmission to the rotor. The 4-hole mounting flange conforming to the same ISO standard simplifies alignment on standardized motor or bracket interfaces.
The unit is intended for HLP mineral oil specified in DIN 51524, ensuring correct viscosity and oxidation stability in industrial machinery. A cleanliness class of ISO 4406 19/16/13 limits particle contamination to protect vane faces from abrasive wear. The suction port is threaded G1/2, providing a common size for low-pressure intake piping. The pressure port uses a G3/8 thread to connect the pump outlet to the hydraulic manifold. A G1/4 thread on the leakage port routes case drain flow back to tank or filter. The inlet side may see an absolute suction pressure up to 2.5 bar without overstressing the shaft seal, while a minimum of 0.8 bar absolute is required to prevent cavitation at high speed. Case drain pressure must stay below 2 bar to avoid overloading shaft bearings and disturbing internal balancing.
Technical Specifications
Cleanliness Class
ISO 4406 19/16/13
Displacement
10 cm3/rev
Drive Shaft Type
Cylindrical With Key (ISO 3019-2)
Hydraulic Fluid
HLP Mineral Oil (DIN 51524)
Leakage Port Thread
G1/4
Max Drain Port Pressure
2 bar
Maximum Flow
18.0 l/min
Maximum Operating Pressure
100 bar
Maximum Suction Pressure (abs)
2.5 bar
Maximum Torque
50 Nm
Minimum Speed
900 rpm
Minimum Suction Pressure (abs)
0.8 bar
Mounting Flange
4-Hole (ISO 3019-2)
Pressure Port Thread
G3/8
Suction Port Thread
G1/2
1620 Old Apex Road
Shipping & Payment Options
