Bosch Rexroth | AZPF-11-005LCN20MB
AZPF-11-005LCN20MB
Request a Quote
In-Stock, Ships 3-5 Days
What Happens Next?
Email Confirmation
You will get an email confirming we have received your inquiry.
Dedicated Account Manager
A team member will review your request and be in touch concerning any questions or specifications.
Quote Delivered
You will receive a comprehensive quote tailored to your specific needs.
The AZPF-11-005LCN20MB is a pump in Bosch Rexroth’s AZPF External High Performance Gear Pumps series and is intended to move hydraulic oil in automated machinery. It displaces 5.5 cm³ per revolution, giving designers a clear basis for flow calculations. The shaft is designed for counter-clockwise rotation, so drive orientation must match this direction. Continuous circuit pressure is limited to 250 bar, while 280 bar can be applied for short duty cycles; pressure spikes may reach 300 bar without overstressing the housing. The unit supports speeds up to 4000 rpm, which pairs well with compact high-speed motors. When system pressure stays below 100 bar, it may operate at 500 rpm, allowing low-flow standby modes that reduce energy use.
For fully loaded operation with 25 mm²/s oil, the minimum speed increases to 700 rpm to maintain film strength inside the gear set. Ambient temperature limits vary by seal selection: FKM seals permit −20 °C to +110 °C, whereas NBR seals allow −30 °C to +80 °C, covering a wide range of climates and fluids. Installation uses a two-bolt Ø50 mm mounting flange, and two M10 bolts secure the body to the mating surface. A 17 mm shaft end delivers torque to the gears without special adapters, and the assembly weighs 2.6 kg, keeping mobile power packs lightweight. These parameters define the mechanical envelope and ensure compatibility with standard hydraulic power units.
Technical Specifications
Ambient Temp (fkm)
-20 to +110 °C
Ambient Temp (nbr)
-30 to +80 °C
Direction Of Rotation
Counter-Clockwise
Displacement
5.5 cm³/rev
Max Continuous Pressure
250 bar
Max Intermittent Pressure
280 bar
Max Pressure Peak
300 bar
Max Speed (at P2)
4000 rpm
Min Speed (<100 Bar)
500 rpm
Min Speed (p2, V=25 Mm²/s)
700 rpm
Mounting Bolts
2 × M10
Mounting Flange
2-Bolt Ø50 mm
Shaft End Diameter
17 mm
Weight
2.6 kg
1620 Old Apex Road
Shipping & Payment Options
